Honeywell DC1000 Series Product Manual page 35

Displays
Default Value
shown except for
examples
Time set for Alarm 2
SET SET
Alarm Code for Alarm 3
SET SET
Time set for Alarm 3
SET SET
Hysteresis for alarms
SET SET
Main Control (OUT1) **0
example
Lower Limit of linear output
SET SET
Main Control (OUT1) **
example
Upper Limit of linear output
SET SET
Sub Control (OUT2) **
example
Lower Limit of linear output
SET SET
Sub Control (OUT2) **
example
Upper Limit of linear output
SET SET
Auxiliary Output
example
Lower Limit of Aux. output
SET SET
Auxiliary Output
example
Upper Limit of Aux. output
SET SET
Motor Time
SET SET
8/05
Parameter
* Range: 0-99 min, 59 seconds
0= flickering alarm, 99:59= continual alarm
Other = Time delay for alarm
* Refer to Table 4-3 for Alarm Codes.
* Range: 0-99 min, 59 seconds
0= flickering alarm, 99:59= continual alarm
Other = Time delay for alarm
Sets the hysteresis for alarm actuation
(Range=0 to 1000)
ON: PV<=(SPHYS1)
OFF: PV>(SP+HYS1)
Used to adjust the linear control output during calibration
* DO NOT change the value without technical assistance
Used to adjust the linear control output during calibration
* DO NOT change the value without technical assistance
Used to adjust the linear control output during calibration
* DO NOT change the value without technical assistance
Used to adjust the linear control output during calibration
* DO NOT change the value without technical assistance
Used to adjust the linear control output during calibration
* DO NOT change the value without technical assistance
Used to adjust the linear control output during calibration
* DO NOT change the value without technical assistance
Three Position Step Control - This is the time it takes the
motor to travel from 0 to 100% (fully closed to fully
open). This time can usually be found on the nameplate
of the motor.
Range: 5 – 200 seconds
DC1010/1020/1030/1040 Product Manual
Configuration
Description
27