Honeywell DC1000 Series Product Manual page 33

Displays
Default Value
Shown
Main Control (OUT 1)
Cycle of Control Output
SET SET
Main Control (OUT 1)
Actuation of Hysteresis
SET SET
Sub Control (OUT 2) *
P Value (Proportional Band)
SET SET
Sub Control (OUT 2) *
I Value (Integral Value)
SET SET
Sub Control (OUT 2) *
D Value (Derivative Time)
SET SET SET
Sub Control (OUT 2) *
Cycle of Control Output
SET SET SET
Sub Control (OUT 2) *
Actuation of Hysteresis
SET SET SET
Main Control (OUT 1)
Gap
SET SET
Sub Control (OUT 2) *
Gap
SET SET
Function Lock
SET SET
* Will only appear in models with "OUT2" option.
8/05
Parameter
Output Type (SSR → 1, 4-20mA → 0, Relay → 10)
Range: 0 to 150 seconds
For On/Off Control (P1=0)
ON: PV<= (SP – HYS1)
OFF: PV> (SP + HYS1)
Same as P1 Configuration
Same as I1 Configuration
Same as D1 Configuration
Same as CYT1 Configuration
Same as HYS1 Configuration
Control Output is turned off before reaching setpoint
Turning Point = SP – GAP 1; Off = (OUT 1 = Heat)
Control Output is turned off before reaching setpoint
Turning Point = SP + GAP 2; On = (OUT 2 = Cool)
Refer to Section 4.4 for Mode access designations.
DC1010/1020/1030/1040 Product Manual
Configuration
Description
(Range 0-1000)
25