Table of Contents
Advertisement
Programming Examples
Transferring the Logic Analyzer Configuration
Transferring the Logic Analyzer Configuration
This program uses the SYSTem:SETup query to transfer the configuration of
the logic analyzer to your controller. This program also uses the
SYSTem:SETup command to transfer a logic analyzer configuration from the
controller back to the logic analyzer. The configuration data will set up the
logic analyzer according to the data. It is useful for getting configurations for
setting up the logic analyzer by the controller. The SYSTem:SETup
command differs from the SYSTem:DATA command because it only transfers
the configuration and not acquired data.
10
! ****************** SETUP COMMAND AND QUERY EXAMPLE ********************
20
!
30
!
40
! ********************* CREATE TRANSFER BUFFER *************************
50
! Create a buffer large enough for the block data. See "Sending Queries
51
! to the Logic Analyzer" for how to calculate buffer size for data.
52
! buffer is only big enough for setup information.
53
!
60
ASSIGN @Buff TO BUFFER [320000]
70
!
80
! **************** INITIALIZE HPIB DEFAULT ADDRESS *********************
90
!
100
REAL Address
110
Address=707
120
ASSIGN @Comm TO Address
130
!
140
CLEAR SCREEN
150
!
160
! ************* INTITIALIZE VARIABLE FOR NUMBER OF BYTES *****************
170
! The variable "Numbytes" contains the number of bytes in the buffer.
180
!
190
REAL Numbytes
200
Numbytes=0
210
!
220
! ************** RE-INITIALIZE TRANSFER BUFFER POINTERS ******************
230
!
240
CONTROL @Buff,3;1
250
CONTROL @Buff,4;0
260
!
18–14
for the HP 16554A/HP 16555A/HP 16555D
This
Advertisement
Table of Contents
