Writing The Mds; Erasing/Initializing The Mds - Siemens MOBY series User Manual

R 01.04
4.2.3

Writing the MDS

A data block can be written to the MDS. The data block which is valid in the
editor is indicated as the default for each write access. The default length or
end address can still be changed to another value during the write-access.
4.2.4

Erasing/Initializing the MDS

The "erase/initialize MDS" function is used to write the entire MDS with a
certain value in a very short time. The erasure value can be entered in a
subsequent menu. After the deletion function has been performed, the memory
in the editor is also erased with the value which was entered. With the
MOBY I/U, the correct size of the MDS memory must be set (Extras/MOBY I
Setup or Extras/MOBY U Setup) before this function is performed.
STG Hand-Held Terminal
(5)J31069-D0126-U001-A5.1-7418
The "MOBY D/E/F/I/U" Programs
E-23