Manual Operation Mode - Mitsubishi Electric MELSERVO-J2S-S061 Specifications And Instruction Manual

5.4 Manual operation mode

For machine adjustment, home position matching, etc., jog operation or a manual pulse generator may be
used to make a motion to any position.
5.4.1 Jog operation
(1) Setting
Set the input signal and parameters as follows according to the purpose of use. In this case, the point
table No. selection 1 to 5 signals (DI0 to DI4) are invalid:
Item
Manual operation mode selection
Servo motor rotation direction
Jog speed
Acceleration/deceleration time constant Point table No.1
(2) Servo motor rotation direction
Parameter No. 1 Setting
0
1
ST1:ON
CCW
Parameter No. 1
Automatic/manual selection signal (MDO)
Parameter No.1
Parameter No.13
Forward Rotation Start (ST1) ON
CCW rotation
CW rotation
CW
ST2:ON
0
Setting Method
Servo Motor Rotation Direction
Reverse Rotation Start (ST2) ON
ST2:ON
CCW
CW
ST1:ON
Parameter No. 1
24
Description
Open MDO-SG (OFF).
Refer to (2) in this section.
Set the speed of the servo motor.
Use the acceleration/deceleration
time constants in point table No.1.
CW rotation
CCW rotation
1
BCN-B11127-479*