Mower Deck Adjustment (Levelness); Parking Brake Adjustment; Engine Adjustments & Repair; Mower Blade Replacement - Snapper OUT FRONT Z-RIDER ZF2100DKU Safety Instructions And Operator's Manual

Section 4 - ADJUSTMENTS & REPAIR
4.2.1.
MOWER DECK ADJUSTMENT (LEVELNESS) 4.3
SIDE to SIDE and FRONT to REAR
(continued from previous page)
5. Retighten leveling bracket bolts.
6. Remove both bolts (one from each side) from the
front portion of the link weldment. See Figure 4.3. The
front caster wheel will drop to the ground.
7. Tum ball joint in or out until ball joint anchor hole
aligns with mounting hole. Reinstall bolt and tighten
securely. Use same procedure on other caster wheel.
See Figure 4.3.
8. Reinstall bolts and tighten securely.
9. Remove blocks from under front of deck.
10. Side to Side Level: Check blade tips by
rotating blades until tips are pointing to the side of
the deck. Check the measurement of outside
blade tips to the ground on both blades. The
measurement of each outside blade tips should
be within 118"of each other.
11. Front to Rear Level: Check blade tips by
rotating blades until tips are pointing to the front 4.5
and rear of deck. Check the blade tip
measurements of each blade. Front to rear
measurement should be 114"to 318" higher in the
rear.
CASTER WHEEL BRACKET
//
PARKING BRAKE ADJUSTMENT
4.3.1 The park brake can be adjusted by
removing the rod from the lever and
rotating clockwise to increase brake
tension. When properly adjusted the park
brake lever should require 18 to 22 pounds
force to set the brake. If this adjustment
does not result in proper brake action,
contact your authorized Snapper dealer for
corrective action. See Figure 4.4.
I ' Oni'n w',°'°°
operate machine if brakes are t
g properly.
4.4 ENGINE ADJUSTMENTS & REPAIR
Refer to the engine owner's manual for engine
adjustments and/or repairs.
MOWER BLADE REPLACEMENT
4.5.1. BLADE WEAR LIMITS
1. Inspect blade frequently for signs of
excessive wear or damage. See Figure 4.5.
WARNING
Wear heavy leather gloves when handling or working
around cutting blades. Blades are extremely sharp
and can cause severe injury. DO NOT use a cutting
blade that shows signs of excessive wear or
damage.
!
ROTATE BALLJOINTIN
OR OUTTO ALIGN WITH
REMOVE HOLEIN CASTER WHEEL
BOLT BRACKET
FIGURE 4.3
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blades running. Stop
blades. Stop engine. Set brake. Remove key.
Remove spark plug wires from spark plugs and (gas
only) secure wires away from spark plugs. Engine
and components are HOT. Avoid serious burns by
allowing all parts sufficient time to cool.
PARKING
BRAKE
LEVER
ROTATE BRAKE PARKING
ROD CLOCKWISE BRAKE ROD
TO TIGHTEN
BRAKE
FIGURE 4.4
17