Important Safety Instructions; Section 1 - Familiarization - Snapper OUT FRONT Z-RIDER ZF2100DKU Safety Instructions And Operator's Manual

Section 1 - FAMILIARIZATION
OPERATOR'S SEAT
MOTION
CONTROL
(JOYSTICK)
CONTROLPANEL
IGNITION AMP BLADE SWITCH
SWITCH METER ,/
DECK
LIGHT LIFT
HOUR
SWITCH SWITCH
METER
FUEL TANK
PARKING BRAKE
ENGINESPEED
CONTROL
CONTROL PANEL
(SEEINSET)
DECK HEIGHT OF
CUT DECAL
DECK COVER
CASTER
WHEEL
BRACKET
DISCHARGE
DEFLECTOR
FIGURE 1.1
1.1 INTRODUCTION
This manual has been prepared for the operator's of the
SNAPPER OUT FRONT Z-RIDER. Its purpose, aside
from recommending standard operating procedures and
routine service requirements, is to promote SAFETY
through the use of accepted operating practices. Read,
Understand and Follow the IMPORTANT SAFETY
INSTRUCTIONS on Page 2 and 3 of this manual and All
SAFETY messages on the OUT FRONT Z-RIDER and its
attachments before operating. SNAPPER recommends
returning the OUT FRONT Z-RIDER to an authorized
SNAPPER dealer annually for inspection and addition of
any new devices which might upgrade the safety of the
mower.
1.2 NOMENCLATURE
The nomenclature information above, Figure 1.1, shows
the essential parts of the SNAPPER OUT FRONT Z-
RIDER. It is recommended that all operator's of this
equipment become thoroughly familiar with the controls,
components, and operation of this machine before
operating. Specific details involving the engine are
found in the separate engine owner's manual. Study
these manuals before operating and keep both handy
for future reference. For the nearest SNAPPER dealer
in your area, check the yellow pages under the heading
LAWN MOWERS. For engine parts and service, look
for the engine manufacturer's dealers under the
heading, ENGINES - gasoline.