Getting Started; Installing Ni-Daq Driver Software; Installing Other Software; Installing The Hardware - National Instruments NI 6602 User Manual

Chapter 1 Introduction
Caution Damage can result if these lines are driven by the sub-bus. NI is not liable for any
damage resulting from improper signal connections.

Getting Started

Installing NI-DAQ Driver Software

Installing Other Software

Installing the Hardware

NI 660x User Manual
The specification permits vendors to develop sub-buses that coexist with
the basic PCI interface on the bus. Compatible operation is not guaranteed
between devices with different sub-buses nor between devices with
sub-buses and PXI. The standard implementation for CompactPCI does not
include these sub-buses. The PXI TIO Series device works in any
CompactPCI chassis adhering to the PICMG 2.0 R3.0 core specification.
PXI-specific features are implemented on the J2 connector of the bus. The
PXI device is compatible with any chassis with a sub-bus that does not
drive the lines used by that device. Even if the sub-bus is capable of driving
these lines, the PXI device is still compatible as long as those pins on the
sub-bus are disabled by default and never enabled.
Before installing your DAQ device, you must install the software you plan
to use with the device.
If you are using NI-DAQ 7.1 or later, refer to the DAQ Getting Started
guides, which you can download at
Started guides offer NI-DAQ users step-by-step instructions for installing
software and hardware, configuring channels and tasks, and getting started
developing an application.
If you are using other software, refer to the installation instructions that
accompany your software.
The DAQ Getting Started guides contain non-software-specific
information about how to install PCI, PXI, PCMCIA, and USB/IEEE 1394
devices, as well as accessories and cables.
ni.com/manuals
1-2
. The DAQ Getting
ni.com