Sending A Network Message Using Site-Based Addressing - Nortel Enterprise Edge 2.0 User Manual

6 Enterprise Edge 2.0 Message Networking User Guide

Sending a network message using Site-Based Addressing

Site-Based Addressing lets you send a message to a mailbox at another location on
the network. To use Site-Based Addressing to send a message, you must know the
destination site's network address and the mailbox number of the person you want
to send the message to.
Ask your System Administrator for a list of destination sites on your network.
To use Site-Based Addressing:
Pswd:
OTHR RETRY
0 new 4 saved
PLAY REC
Record message:
Record message:
RETRY PAUSE
Accept rec?
RETRY PLAY
Mbox:
DIR
Address type?
NETW
Network:
RETRY
<site name>
OPTS CC
0 new 0 saved
PLAY REC
Enterprise Edge 2.0 Message Networking User Guide
1. Open your mailbox using ƒ·°⁄.
2. Enter your mailbox password and press OK or £.
OK
3. Press REC or ‹.
ADMIN
4. At the tone, record your message.
5. Press OK or £ to end the recording.
OK
6. Press OK or £ to accept the recording.
OK
7. Press ££.
QUIT
8. Press NETW.
AMIS
Note: This display appears only if AMIS is enabled.
If AMIS is not enabled, this display is
bypassed and the display in step 9 appears.
9. Enter the destination site's Site Prefix and the
OK
destination mailbox number and press OK or £.
10. Press SEND to send the message as it is. Press OPTS
SEND
to assign message Delivery Options Certified, Urgent
or Timed Delivery. Press CC to send the message to
another recipient.
11. Press ® to end this session.
ADMIN
P0911953 Issue 02