Auger Clean-Out Startup - Marco DUSTMASTER Operator's Manual

W-577
Before using this
equipment, read,
understand and follow
all instructions in the
Operator's Manuals with
this equipment. If the
user and/or assistants
cannot read or
understand the warnings
and instructions, the
employer of the user
and/or assistants must
provide adequate and
necessary training to
ensure proper operation
and compliance with
all safety procedures
pertaining to this
equipment. If Operator's
Manuals have been lost,
visit www.marco.us or
call (563) 324-2519 for
replacements. Failure to
comply with the above
warning could result in
death or serious injury.
W-586
Moving parts can
present an area where
crushing, pinching,
entanglement or
amputation may occur.
Do not place body parts
or foreign objects in any
area where there are
moving parts. Failure to
comply with the above
warning could result in
death or serious injury.
W-587
Escaping fluid under
pressure can penetrate
skin and tissue causing
injury. Stop pump and
relieve pressure before
attempting maintenance
or repair. Ensure all
fittings are properly
tightened before
restoring pressure. If
injury should occur,
immediately seek
medical attention.
Failure to comply with
the above warning
could result in death or
serious injury.
OPERATING INSTRUCTIONS

Auger Clean-out Startup

Auger Clean-out System Startup Instructions:
The Auger Clean-out System removes collected dust and debris from the bottom of the
hopper to the Discharge Auger for discharging.
1) Ensure personnel are clear of auger conveyors.
2) Open Butterfly Valve (1) on Discharge Auger (3).
3) Activate screw conveyors by moving Hydraulic Control Valve Lever (2) clockwise to
detent position.
Note: Moving Hydraulic Control Valve Lever (2) counter-clockwise will allow the conveyor
system to run in reverse but will not lock in position. Only operate in reverse
momentarily to attempt to dislodge an item.
3
Dustmaster 28,000 CFM Tier 4 Diesel Dust Collectors
®
1
2
16