Pulser System Startup - Marco DUSTMASTER Operator's Manual

W-562
Always depressurize
the entire system,
disconnect all power
sources and lockout/
tagout all components
before any maintenance
or troubleshooting is
attempted. Failure to
comply with the above
warning could cause
electrical shock and
inadvertent activation of
equipment resulting in
death or serious injury.
This equipment is not
intended for use in
any area that might
be considered a
hazardous location, as
described in the National
Electric Code NFPA
70, Article 500. Use of
this equipment in a
hazardous location could
cause an explosion or
electrocution. Failure to
comply with the above
warning could result in
death or serious injury.
W-590
When performing
service or maintenance
on systems or devices
requiring access from
an elevated position,
you must comply
with all OSHA, local,
City, State, Province,
Country and jurisdiction
regulations, ordinances
and standards, as
related to working in
elevated work areas.
Failure to comply with
the above warning
could result in death or
serious injury.
15
Dustmaster 28,000 CFM Tier 4 Diesel Dust Collectors
®
OPERATING INSTRUCTIONS

Pulser System Startup

Pulser System Startup Instructions:
The Pulser System is a cleaning system for the filter cartridges. This system blows a burst
of air into a set of filters to dislodge dust from the filters into the hopper. To change time
duration of pulse, (see Adjust Pulse Separation).
1) Close Ball Valve (1).
2) Turn Switch (4) clockwise to "ON".
3) Supply compressed air to Regulator (3). Adjust compressed air pressure to 90 PSI
using Regulator Control Knob (2). Normal operating range is 90-95 PSI.
NOTE: The timer controller is pre-set to pulse one row of filters every 8 seconds (see
Adjust Pulse Separation.)
4) After use, turn Switch (4) counterclockwise to "OFF".
5) Disconnect supply of compressed air to the Regulator (3).
6) Open Ball Valve (1) to relieve pressure in Pulser System.
1
3
2
4