BenQ Mainstream MP510 User Manual page 43

5. Disconnect the lamp connector by
pushing it against the projector while
pulling it up.
6. Loosen the screw that secures the lamp.
7. Lift the handle so that it stands up. Use the
handle to slowly pull the lamp out of the
projector.
• Pulling it too quickly may cause the lamp to
break and scatter broken glass in the projector.
• Do not place the lamp in locations where water
might splash on it, children can reach it, or
near flammable materials.
• Do not insert your hands into the projector
after the lamp is removed. If you touch the
optical components inside, it could cause color
unevenness and distortion of the projected
pictures.
8. As shown in the figure, hold the new lamp
first and align the lamp with the
compartment in the projector, and then insert
the lamp all the way into the projector.
9. Tighten the screw that secures the lamp.
• Loose screw may cause a bad connection,
which could result in malfunction.
• Do not over tighten the screw.
10. Connect the lamp connector to the projector.
11. Place the lamp cords back to the slots.
Maintenance 43