Replacing The Lamp - BenQ Mainstream MP510 User Manual

Mainstream series digital projector

Hide thumbs Also See for Mainstream MP510:

Table of Contents

Lamp-usage time exceeded

Replace lamp (refer to User Manual)

Then reset lamp timer

Replacing the lamp

•

To reduce the risk of electrical shock, always turn the projector off and disconnect the

power cord before changing the lamp.

•

To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes

before replacing the lamp.

•

To reduce the risk of injuries to fingers and damage to internal components, use caution

when removing lamp glass that has shattered into sharp pieces.

•

To reduce the risk of injuries to fingers and/or compromising picture quality by touching

the lens, do not touch the empty lamp compartment when the lamp is removed.

•

This lamp contains mercury. Consult your local hazardous waste regulations to dispose of

this lamp in a proper manner.

Turn the power off and disconnect the

projector from the wall socket. If the lamp is

hot, avoid burns by waiting for approximately

45 minutes until the lamp has cooled.

Turn the projector over. Then loosen the

screws on the lamp cover.

Remove the lamp cover from the projector.

Do not turn the power on with the lamp cover

removed.

Remove the lamp cords from the slots.

Maintenance

If this warning message displays, the projector will

shut down in 40 seconds. The lamp MUST be

replaced before the projector will operate normally.

Table of Contents