If You Forget The Password; Entering The Password Recall Procedure; Changing The Password - BenQ Mainstream MP510 User Manual

iii. Press Down to cancel the password set-up and return to the OSD menu.
To disable password protection, go to the
the OSD menu system. Select Off by pressing
Though the password function is disabled, you need to keep the old password in hand should
you ever need to turn the password function back on and change the old password.

If you forget the password

If the password function is activated, you will be
asked to enter the four digit password every time
you turn on the projector. If you enter the wrong
password, the password error message displays.
You can retry by pressing
not record the password in this manual, and you
absolutely do not remember it, you can use the
password recall procedure.

Entering the password recall procedure

Press and hold Right on the projector for 3 seconds. The projector will display 4 sets of
coded number on the screen. Write down the number and turn off your projector. Seek help
from the local BenQ service center to decode the number. You may be required to provide
proof of purchase documentation to verify that you are an authorized user of the projector.

Changing the password

1. Press MENU on the projector or MENU on the remote control to open the on-
screen menu and go to the
2. Press Left or
3. Enter the old password.
i. If the password is correct, you can go on to enter new password.
ii. If the password is incorrect, a "Password Error" message displays. Press
try again or press
4. Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is
available to you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
5. Perform one of the following 3 steps.
i. Press AUTO to confirm.
ii. Press Up to try again.
iii. Press Down to cancel the set-up and return to the on-screen menu.
6. Confirm the new password by re-entering the new password.
7. Perform one of the following 3 steps.
i. Pressing AUTO completes the procedure.
ii. Press Up to try again.
iii. Press Down to cancel the set-up and return to the on-screen menu.
Up, or if you did
Setting >
Right.
Down to cancel.
Setting >
Password menu after opening
Left or Right.
Password error
Try again
Forgot password? Please refer to the User's Manual
Change Password menu.
Up to
Operation 23