Using Functions Of Remote Control - Sherwood RX-773 Operating Instructions Manual

USING FUNCTIONS OF REMOTE CONTROL

• This remote control can control up to 8 different components.
• Before operating audio and video components other than this receiver with using this remote control, the setup code for each
component should be entered.
• For system remote control operation, "000" was stored previously in the memory of the device button "CD" for Sherwood CD
player, "DVD" for Sherwood DVD player, "AUX" for Sherwood tape deck and "TV" for Sherwood TV respectively as its factory
setup code. So, you don't need to enter its code for each Sherwood component except in such a case that its code does not work.
Note :
• If the transmission signal which this remote control emits is changed into "RF"(Radio Frequency), this remote control cannot
control other audio and video components. (For details, refer to "Changing the transmission signal" on page 23.)
Entering a setup code
• Setup code entry is the easiest way to program this
remote control for operating audio and video components.
1.
Turn on the component you want to operate.
2.
Find the setup codes according to the type and the
brand name of your component, referring to "Setup
Code Table" on page 37.
3.
Press and hold down both the ENTER/MEMORY
button and the desired one of the DEVICE buttons for
more than 2 seconds.
• Then "LEARN" is displayed on the LCD screen for several
seconds.
Notes :
• The AUDIO button is unavailable for the audio components
other than this receiver.
• During setting operation, to exit from the setting mode,
press any of the DEVICE buttons.
4.
While "LEARN" is displayed, press the CURSOR UP
(▲)/DOWN(▼) buttons to select the setup code mode
("CODE"), then press the ENTER/MEMORY button.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, the mode changes as follows :
LEARN RF-IR
CODE PUNCH
• Then "PRESET" and 3 digit number are displayed.
• If "PRESET", etc. go off, start again from the above step 3.
5.
While "PRESET", etc. are displayed, enter a 3 digit
code and press the ENTER/MEMORY button.
Example: When entering "001".
• Then "OK" is displayed on the LCD screen.
• To be sure that the setup code is correct, press the
POWER ON (or STANDBY) button, aiming the remote
sensor on the component.
• If the setup code is correct, your component will be
turned off.
• When your component is not turned off, repeat the above
steps 2 to 5, trying entering each code for your
component until you find one that works.
• If "NG" is displayed, retry entering the correct setup code
while "PRESET" and 3 digit number are displayed.
15
DELETE MACRO