Sherwood RX-773 Operating Instructions Manual page 16

6.
Operate the component using the corresponding
function buttons.
• If any of buttons fails to operate as they should, start from
the step 1 again to enter the correct setup code.
Note :
• Manufacturers may use different setup codes for the same
product category. For that reason, it is important that you
check to see if the code you have entered operates as
many controls as possible. If only a few functions operate,
check to see if another code will work with more buttons.
Searching a setup code
• In addition to enter a setup code using "Setup Code Table" on page 37, it is also possible to search through all the codes
that are stored in the library of this remote control.
1.
Turn on the component you want to operate.
2.
Perform the steps 3 and 4 in "Entering a setup code"
procedure on page 15 to select the setup code mode
("CODE").
3.
While "PRESET" is displayed, search a setup code,
aiming the remote control at the remote sensor on the
component.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, the setup code is selected one by one.
• If the selected code is correct, your component will be
turned off.
• When your component is not turned off, repeat this step
until you find one that works.
7.
Repeat the above steps 1 to 6 for each of your other
components.
4.
While "PRESET" is displayed, press the
ENTER/MEMORY button to store the setup code.
• Then "OK" is displayed on the LCD screen.
5.
Operate the component using the corresponding
function buttons.
• If any of buttons fails to operate as they should, start from
the step 1 again to find the correct setup code.
6.
Repeat the above steps 1 to 5 for each of your other
components.
16