Sherwood RX-773 Operating Instructions Manual page 20

Operating a macro function
• Aim the remote control at the REMOTE SENSORs of the components to be controlled and press the MACRO button you want.
Example : When pressing "M1" button.
Programming a punch-through function
• The punch-through function allows the volume controls, channel controls or transport controls to link to a different device while
a device is controlled with this remote control as a master device.
• For example, since this receiver will likely be used as the sound system while watching TV, you may want to use volume
controls to operate this receiver although this remote control is set to control the TV.
1.
Perform the steps 3 and 4 in "Entering a setup code" procedure on page 15 to select a master device and the punch-
through mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for several seconds.
2.
While "VOL" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the desired punch-
through mode, then press the ENTER/MEMORY button.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, the mode changes as follows:
→ VOL : The volume punch -through mode allows the
"VOLUME ▲/▼" and "MUTE" buttons to operate a
different device.
DELETE : All punch-through deleting mode.
PLAY : The transport punch-through mode allows the
"◀ ◀", "●", "▶ ▶", "◀ ◀", " ", "▶ ▶ " , "◀/ " and
"▶" buttons to operate a different device.
→ CH : The channel punch-through mode allows the
"CHANNEL ∧/∨" and "CH. LEVEL" buttons to
operate a different device.
• Then the device to which you can link the selected punch-
through mode is displayed.
Notes:
• The codes programmed into a MACRO button will be transmitted at an
interval of 0.5 seconds. However, some components may not be able to
complete one operation in 0.5 seconds and may miss the next code.
In this case, the macro function cannot control the corresponding components
correctly.
• Be sure to use the remote control within the remote control operation range of
the components.
• Depending on the operation status of the components, etc., the macro
function cannot control the corresponding components correctly.
3.
While the device is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the desired punch-
through device, then press the ENTER/MEMORY button.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, depending on the selected punch-through mode,
punch-through devices and the one punch-through
deleting mode ("DELETE") are selected as follows :
• In case of the volume punch-through,
→ AUDIO
• In case of the transport punch-through,
→ CD
• In case of the channel punch-through,
→ TV
• Then "OK" is displayed and the current punch-through
mode is displayed.
20
DELETE TV ←
DELETE DVD VCR
DELETE SAT CABLE
AUX ←
VCR ←