Sherwood RX-773 Operating Instructions Manual page 22

Continued
3.
While the device is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the one punch-
through deleting mode ("DELETE"), then press the
ENTER/MEMORY button.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons
are pressed, depending on the selected punch-
through mode, the punch-through devices and the
deleting mode ("DELETE") are selected.
• Then "OK" is displayed and the current punch-
through mode is displayed .
Erasing all the punch-through functions programmed under a master device mode
1.
Perform the steps 3 and 4 in "Entering a setup code"
procedure on page 15 to select a master device and
the punch-through mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for several
seconds.
2.
While "VOL" is displayed, press the CURSOR UP(▲)/
DOWN(▼) buttons to select the all punch-through
deleting mode ("DELETE").
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, the mode changes as follows:
→ VOL
DELETE PLAY
• Then "DELETE" is displayed .
CH ←
22
4.
While the punch-through mode is displayed, repeat the
above steps 2 and 3 to erase other punch-through
function under the same master device mode.
5.
To erase punch-through functions under other master
device mode, repeat the above steps 1 to 4.
3.
While "DELETE" is displayed, to erase all the punch-
through functions programmed under the master
device mode, press ENTER/MEMORY button.
• Then "OK" is displayed and "DELETE" is displayed.
• To exit from the deleting mode, press any of the
DEVICE buttons.
4.
To erase all the punch-through functions programmed
under other master device mode, repeat the above
steps 1 to 3.