Table of Contents
Advertisement
Reprogramming Receiver
This procedure covers how to reprogram the
remote receiver to accept a new remote frequen-
cy from the remote controller. Use these instruc-
tions if you ever replace the two AA batteries in
the remote controller, or if the controller cannot
be activated.
To reprogram remote receiver:
1.
Press and hold Set button on control panel
until Signal indicator light starts to flash (see
Figure 62).
2.
While Signal light flashes, press Set button
on remote controller to complete the setting.
Signal light will stop flashing.
Model G0777/G0777HEP (Mfd. Since 04/19)
Operating Control Panel
Refer to Figure 62 and the following descriptions
to understand the receiver control functions.
A
B
C
D
Figure 62. Machine-mounted controls.
A. Timer Indicator: Illuminates to display auto
shut-down time set by TIMER Buttons on
control panel, or remote controller. If not illu-
minated, the timer function is inactive, and
machine will run until manually turned OFF.
B. Remote Signal Indicator: Flashes when
remote is ready to be reprogrammed.
C. Set Button: Used to reprogram receiver.
D. POWER Switch: Toggles incoming power
ON or OFF.
E. Run Indicator: Illuminates when the dust
collector is ON.
F.
Circuit Breaker/Thermal Overload: Pops
out if machine overloads.
G. Power Indicator: Illuminates when there is
power to the machine.
H. Timer Button: Selects auto shut down time.
Consecutive pushes increase operation time
in 1, 2, 4 or 8 hour intervals—up to 15 hours.
The machine will stop once set time period
ends. To cancel timer before set time has
elapsed, turn Power Switch OFF or press
OFF button on remote controller.
I.
ON/OFF Button: Turns dust collector ON or
OFF.
I
H
G
E
F
-39-
Advertisement
Table of Contents
