Test Run - Grizzly G0777 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Before starting dust collector, you must
first hook it up to your ducting system
with either a blast gate half-opened, a 4"x
2 ⁄ " reducer, or your intended machine
1
2
connected to the other end. This provides
resistance necessary for proper machine
functioning. Without this resistance, the
machine will draw too many amps from the
circuit and cause the breaker to trip.
To test run dust collection system:
1.
Connect dust collector to a half-opened blast
gate, a 4" x 2 ⁄ " reducer, or your intended
1
2
machine (see Notice on this page), then
clear all setup tools away from machine.
2. Review Power Supply on Page 14 and con-
nect machine to power source.
Model G0777/G0777HEP (Mfd. Since 04/19)
3. Toggle power switch (see Figure 36) to ON
(—). Power indicator light will illuminate.
IR Sensor
Power
Switch
START/STOP
TIME
Button
Button
Figure 36. Control panel and remote power
controls.
4. Press ON/OFF button (see Figure 36) to
turn machine ON. Make sure your hand
stays poised over switch in case you need to
quickly turn machine OFF.
5. The machine should run smoothly with little
or no vibration or rubbing noises.
— If you suspect any problems, immediately
turn the machine OFF and disconnect it
from power. Refer to Troubleshooting on
Page 44 to identify and fix any problems. If
you do not solve the problem with the use
of the Troubleshooting guide, contact
our Tech Support at (570) 546-9663 for
assistance.
6.
Press TIMER button on remote control
receiver (see Figure 36) and cycle through
each time setting (1, 2, 4, and 8 hours) to
make sure the indicators illuminate.
7.
Press TIME button on remote control (see
Figure 36) and cycle through remaining times
(9–15 hours) in same manner as Step 6.
8.
Toggle power switch to OFF (O) on receiver
or press START/STOP button on remote
control (see Figure 36) to turn machine OFF.
On/Off
Button
Timer
Button
Remote Control
-27-