Pentair FLECK 5800 XTR Installer Manual page 51

5. Vacation
6. Regeneration
cycle wheel
Note
On metered units, the "Treatment" step on the regeneration cycle wheel will flash when
water is flowing through the unit.
7. Rapid Rinse
8. Tank Refill
9. Treatment
10. Day and time
11. Next scheduled
regeneration
12. Backwash
13. Draw
14. Pause
15. Custom
16. Home
Ref. MKT-IM-006 / B - 16.01.2018
Installer Manual Fleck 5800 - XTR - Programming
→ Halts all scheduled regenerations when pressed; press
again to resume normal operation.
→ Displays the cycle steps the valve will step through during
service and regeneration; the current cycle step is always
shown on green.
→ Water flows from the top of the vessel to the bottom of the
vessel to rinse the media.
→ Brine tank is refilled with water.
→ The unit is treating water.
→ Displays the currently programmed day of the week and
time. This button will flash at the start-up and if the
supercapacitor is discharged
→ Displays the time to next scheduled regeneration, or volume
remaining until regeneration in meter systems.
→ Water flows from the bottom of the vessel to the top of the
vessel to clean and mix the media.
→ Brine is drawn into the media and then slowly rinsed out.
→ Valve comes back in service position to allow brine
preparation after refill. Shown if variable refill/brining
regeneration flow has been selected in master setting.
→ Shown if custom regeneration flow has been selected in
master setting.
→ Displays the home screen.
51 / 122