Ericsson RBS 2308 User Manual page 63

3.
4.
5.
5.4.5 Replacing the Flash Card (If Applicable)
This section describes how to replace the existing flash card in the IXU. This is
done only if a flash card, preloaded with site-specific data, is provided.
Note: Using the OMT, always reload the software and install the appropriate
For information about preloading the flash card, see Chapter Maintenance.
EN/LZT 720 0027 Uen R8A 2006-06-27
If 3-wire is used, set the ground
selector to 3-W.
Ensure that the protective earth is properly connected.
Put back the MBU cover.
IDB after moving a used flash card to another cabinet. This ensures
consistent software and correct configuration.
RBS 2308 and RBS 2309 User's Guide
3
55