Ericsson RBS 2308 User Manual page 53

5.4.1 Unpacking RBS
Unpack the RBS on-site. To avoid damage, the RBS should not be unpacked
elsewhere and then transported to site.
Stop! This product contains components sensitive to ESD. Use an approved
ESD wrist strap, connected to the product grounding point, to avoid damaging
these components.
In order to avoid damage to components due to electrostatic discharges during
unpacking, personnel must not come in contact with the connectors of the RBS.
Ensure that the correct material has been delivered. If the material is damaged,
complain immediately to the supervisor or the transport company.
5.4.2 Installing the Wall Bracket
Note: This section is only applicable for walls with very rough surfaces or
This section describes how to install the wall bracket.
The wall bracket is for use as a complement to the mounting interface of the
Mounting Base Unit (MBU). Typical applications are rough surfaces and other
conditions where the mounting interface for the MBU is not flat. The plate must
also be used if the RBS is to be installed on a pole. See applicable section
below.
EN/LZT 720 0027 Uen R8A 2006-06-27
when the RBS is to be mounted on a pole.
RBS 2308 and RBS 2309 User's Guide
Caution!
45