Ericsson RBS 2308 User Manual page 54

RBS 2308 and RBS 2309 User's Guide
5.4.2.1 Installing the Wall Bracket on a Wall (Alternative)
1.
2.
3.
4.
5.
6.
5.4.2.2 Installing the Wall Bracket on a Pole (Alternative)
1. Choose the appropriate holes. See Figure below.
46
Place the drilling template in the position where the RBS is to be
located.
Use a spirit level to check that the drilling template is horizontal.
Mark the position of the holes to
be drilled.
Note: The wall bracket must not
be used as a drilling template,
to avoid damaging the rust
protection surface.
Remove the template and drill the holes for the fasteners.
Install the wall bracket and
secure it in position with all the
screws provided.
Loosen the four nuts, on which the MBU is to be hung, until only a few
threads remain exposed.
EN/LZT 720 0027 Uen R8A 2006-06-27
U P
P010151A