Bin Control Installation - Hoshizaki KMD-460MAJ Instruction Manual

2. Bin Control Installation

1) Remove the control box cover. Remove the 2 thumbscrews securing insulation
panel (B), then remove insulation panel (B). See Fig. 3.
2) Disconnect the discharge hose from the pump motor, then disconnect the drain valve
drain hose and the overflow drain hose.
3) Disconnect the pump motor connector from the back of the control box, then disconnect
the float switch connector from the control board.
4) Remove the tape securing the bin control.
5) Remove the 2 thumbscrews securing the pump motor and float switch assembly. See
Fig. 4.
6) Being careful not to pull the bin control cable, lift the bin control up out of the water tank.
Being careful not to snag the bin control or bin control cable, slide the water tank, cube
guide, and pump motor and float switch assembly out of the icemaker.
Bin Control Cable
Tape
Drain Valve
Drain Hose
Bin Discharge
Control Hose
Fig. 3
7a) Standard Dispenser Unit or Ice Storage Bin Application: Secure the bin control to
the rear interior wall using the 2 thumbscrews on the rear interior wall. See Fig. 5. Route
the bin control cable vinyl hose through the grommet as illustrated. Do not leave any
slack in the ice drop zone.
for Standard Dispenser Unit or Ice Storage Bin Application
Fig. 5
Thumbscrews
Bin Control
Float Switch
Connector (Black)
Pump Motor
Connector
Thumbscrews
Insulation
Overflow
Panel (B)
Drain Hose
Standard Bin Control Mount Position
Rear Interior Wall
Bin Control Cable
Water Tank
Fig. 4
12
Thumbscrews
Pump Motor
and Float
Switch
Assembly
Cube Guide
Bin Control
Bin Control Cable
Grommet
Vinyl Hose