FUTABA SkyLeaf BP Instruction Manual page 17

This page is an explanation of when to make it into an engine.
9
Installation of Engine and Cowling : GP kit only
1 1
● Temporarily fix Engine Mount to fuselage according to
the width of your engine.
● Drill a hole in the fuel
pipe.
● Engine mount
1 2
● Determine the mounting position of the Engine and
drill four holes of 3 mm into Engine mount.
● M a k e i t a b o u t
46 mm from the
mount tip to the
drive washer face.
● A mark of the standard
is attached to the fire
wall. Position may be
different depending on
your engine.
46 mm
(It is unnecessary in case of EP.)
3 1
● Fix the Engine using a M3 x 25 hexagon screw
(4 pieces) and M3 Nylon Nut, M3 Washer
attached to the engine mount.
4 1
● Cut the part that interferes with the
engine and silencer of the cowling.
● Silencer outlet
5
● Check the position of the engine shaft.
● Needle outlet
● Cut a lot in order
to air cool the
e n g i n e w i t h
Dremel.
● Confirm center
position
17