FUTABA SkyLeaf BP Instruction Manual page 15

This page is an explanation of the case of electric motor.
8 Installation of Motor and Cowling : EP kit only
1 1
● Drill four holes with a 4 mm drill in the position
of the Motor mount figure. Determine the hole
position according to the motor you use.
● There is a mark of the hole position according to
Futaba FMA-5055 KV525 Motor.
1 2
● Fix the Motor with four M4 Nylon Nut, M4 Washer
and M4 × 12 Hexagon bolt.
● Install M4 Nylon Nut and M4 Washer
from the inside of Fuselage.
1 3
● Install motor wiring so that
it is located at the bottom.
(It is unnecessary in the case of engine.)
4
● Attach the Motor controller using the Hook-and-
Loop Tape at the lower part of cowling of the nose.
1 5
● Cowling comes with 4 L-shaped locking tabs. Insert
this locking tab into the hole of fuselage and lower
it downward to lock cowling.
1 6
● Attach Cowling to the fuselage.
● Hole for inserting
lock tab (4 places)
● Insert it backwards, then lock
it by thrusting downwards.
15