FUTABA SkyLeaf BP Instruction Manual page 10

2. Film cutting of main wing
1 1
● There are several holes in the wood at the position shown in the picture. Cut the film of that part.
Strut Screw hole
Strut Screw hole
Control Horn hole
Strut Screw hole
Strut Screw hole
Control Horn hole
10
＜ Upper Wing Front side ＞
＜ Upper Wing Bottom side ＞
Strut holes
Servo hole
＜ Bottom Wing Front side ＞
Strut holes
Servo Wire holes
Wing Screw holes
＜ Bottom Wing Bottom side ＞
Servo hole
Wing Screw holes
Wing Screw holes
Servo Wire holes
Servo hole
Wing Screw holes
Servo hole
● There is a method of using a soldering iron to cut the film.
Touch with a soldering iron along the basewood hole. The
remaining film adheres to the base wood.
Strut Screw hole
Strut holes
Strut Screw hole
Control Horn hole
Strut holes
Strut Screw hole
Strut Screw hole
Control Horn hole