Horizontal Stabilizer - FUTABA SkyLeaf BP Instruction Manual

5

Horizontal stabilizer

1. Instal the Elevators
1 1
● Spread the hinge insert point so that
the paper hinge enters.
Horizontal stabilizer
2 1
● Put four paper hinges in Elevator.
1 3
● Pour CA glue into all
4 hinges.
Make glue wick to the interior.
4 1
● Push the Elevator into the Horizontal stabilizer.
12
Elevator
5
● Pour CA glue into the paper hinge
inserted in the wing.
6
● Move the Elevator after drying. Check that the
aileron is securely attached.
● Attach the Elevator to the other
Horizontal stabilizer by the same work.
7
● Cut the Control Horn for length adjustment.
Ruff up the bottom of the control horn with
sandpaper to help the glue stick to the horn.
＜ Horizontal stabilizer
Bottom side ＞
● Adjust the length and position of
the Control Horn with reference
to the figure below and then
attach it with CA glue.
19mm
＜ Horizontal stabilizer
Bottom side ＞
● Cut the film
according to
the prepared
hole.
Elevator