This Card Configuration (Scsiselect Utility) - Fujitsu PRIMERGY User Manual

3.3 This Card Configuration (SCSISelect Utility)

This card contains the SCSISelect utility in this card's memory. This utility can
change this card settings without removing the SERVER cover or physically setting
the board. SCSISelect utility contains a SCSI disk utilities that can perform low-level
formatting and check the disk medium in a SCSI hard disk drive.
(1) Configure/View Host Adapter Settings
I
Default settings
This card default settings are listed in the table below. If you do not need to change
these default settings, there is no need to execute SCSISelect utility.
For more information on settings, refer to the description for each setting given later
in this guide.
SCSI Bus Interface Difinitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination*
Boot Device Configuration
Boot Target ID
Boot LUN Number *
SCSI Device Configuration (#0 to #15)
Initiate Sync Negotiation
Maximum Sync Transfer Rate*
Enable Disconnection
Initiate Wide Negotiation*
Send Start Unit Command*
Include in BIOS Scan*
*1 The setting is available only when the Multiple LUN Support is enabled.
*2 Enabled only when Host Adapter BIOS is enabled
*3 When the "Support for Ultra SCSI Speed" is set to ｢Enabled｣ and the "Initiate Wide Negotiation" is set to ｢yes｣, the setting
*4 The SCSI terminators of this card are always activated because the jumpers J2 and J4 of this card are short-circuited.
10
1
value of the "Maximum Sync Transfer Rate" is 40 MB/s.
4
3
3
2
2
Default setting
7
Enabled
Automatic
Default setting
0
0
Default setting
yes
40.0
yes
yes
yes
(Be careful not to
change the default
setting.)
yes