0 - 2
LUBRICATION AND MAINTENANCE
DESCRIPTION AND OPERATION (Continued)
GEAR LUBRICANTS
SAE ratings also apply to multiple grade gear
lubricants. In addition, API classification defines the
lubricants usage.
LUBRICANTS AND GREASES
Lubricating grease is rated for quality and usage
by the NLGI. All approved products have the NLGI
symbol (Fig. 2) on the label. At the bottom NLGI
symbol is the usage and quality identification letters.
Wheel bearing lubricant is identified by the letter
"G". Chassis lubricant is identified by the latter "L".
The letter following the usage letter indicates the
quality of the lubricant. The following symbols indi-
cate the highest quality.
Fig. 2 NLGI Symbol
INTERNATIONAL SYMBOLS
DESCRIPTION
Chrysler Corporation uses international symbols to
identify engine compartment lubricant and fluid
check and fill locations (Fig. 3).
FLUID FILL/CHECK LOCATIONS
DESCRIPTION
Fluid fill/check locations are located in each appli-
cable group.
Fig. 3 International Symbols
LUBRICATION POINT LOCATIONS
DESCRIPTION
Lubrication point locations are located in each
applicable group.
SPECIFICATIONS
FLUID CAPACITIES
Fuel Tank . . . . . . . . . . . . . . . . . . . 60.5 L (16.0 gal.)
Engine Oil With Filter – 2.0 L, 2.5 L V6 . . . . 4.25 L
Engine Oil With Filter – 2.4 L . . . . . 4.7 L (5.0 qts.)
Engine Oil Without Filter – 2.0 L, 2.5 L V6 . . . 3.8 L
Engine Oil Without Filter – 2.4 L . . . 4.3 L (4.5 qts.)
Cooling System – 2.0 L . . . . . . . . . . . 8.1 L (8.5 qts.)
Cooling System – 2.4 L . . . . . . . . . . . 8.5 L (9.0 qts.)
Cooling System – 2.5 L . . . . . . . . . . 9.9 L (10.5 qts.)
Automatic Transaxle - Estimated
Service Fill . . . . . . . . . . . . . . . . . . 3.8 L (4.0 qts.)
Automatic Transaxle - Overhaul Fill
Capacity with Torque Converter
Empty . . . . . . . . . . . . . . . . . . . . . . 8.6 L (9.1 qts.)
Manual transaxle . . . . . . . . . . . . . . . . 2.1 L (2.2 qt.)
Differential . . . . . . . . . . . . . . . . . . . . . 0.95 L (1 qt.)
JA
(4.5 qts.)
(4.0 qts.)