Brake Fluid Level Switch - Chrysler Stratus RHD 1999 Electronic Service Manual

JA
REMOVAL AND INSTALLATION (Continued)
Fig. 48 Bleeding Tubes Attached to Master Cylinder
With Out ABS
Fig. 49 Bleeding Master Cylinder
NOTE: It is not necessary to bleed the entire hy-
draulic system after replacing the master cylinder.
However, the master cylinder must have been bled
and filled upon installation.
INSTALL
(1) Position master cylinder assembly on studs of
power brake unit, aligning push rod on power brake
vacuum booster with piston of master cylinder.
(2) Install the 2 master cylinder to power brake
vacuum booster mounting nuts (Fig. 46). Tighten
both nuts to a torque of 28 N·m (250 in. lbs.).
(3) Connect brake tubes to master cylinder pri-
mary and secondary ports (Fig. 47) or (Fig. 48). Then
tighten the tube nuts to a torque of 17 N·m (145 in.
lbs.).

BRAKE FLUID LEVEL SWITCH

The master cylinder or brake fluid reservoir does
not have to be removed from the vehicle for replace-
ment of the brake fluid level sensor.
(1) Remove wiring harness connector from brake
fluid reservoir level sensor (Fig. 50).
Fig. 50 Master Cylinder Fluid Level Sensor
(2) Compress the retaining tabs (Fig. 51) on the
end of the brake fluid level sensor.
Fig. 51 Brake Fluid Level Switch Retaining Tabs
(3) While compressing retaining tabs, grasp oppo-
site end of brake fluid level sensor and pull it out of
master cylinder fluid reservoir (Fig. 52).
POWER BRAKE BOOSTER (2.0L/2.4L ENGINE)
REMOVAL
(1) Remove the remote ground cable from the
ground stud located on the left strut tower (Fig. 53).
(2) Correctly isolate remote ground cable when ser-
vicing vehicle by installing the ground cable insulator
on the strut tower ground stud as shown (Fig. 54).
BRAKES 5 - 25