Appendix A: Bulk Oil Instructions - Frymaster FQE60U FilterQuick easyTouch Installation, Operation And Maintenance Manual

FQE60U FILTERQUICK™ easyTouch
A.1.1 Bulk Oil Systems
Bulk oil systems have large oil storage tanks,
typically located in the rear of the restaurant,
that are connected to a rear manifold on the
fryer. Waste oil is pumped from the fryer, via
a fitting located on the rear of the fryer
labeled DISPOSE (see Figure 1), to the
disposal tanks and fresh oil is pumped from
the tanks, thru the fitting located on the rear
of the fryer labeled FILL, to the fryer (see
Figure 1). Connect the bulk oil connections
to plug located on the rear of the fryer (see
Figure 2). The wiring diagram is located on
the next page.
It is imperative that the fryer system be
completely power cycled after changing any
fresh or waste oil settings.
The FQE60U FilterQuick
equipped for use with bulk oil systems, have
an onboard fresh oil reservoir that may or
may not be supplied by the bulk oil provider.
For fryers batteries with two or more vats,
remove the cap and insert the standard
fitting into the jug with the metal cap resting
on the lip of the jug. The oil is pumped in and
out of the jug or saddle reservoirs on singles,
through the same fitting. (see Figure 3).
Figure 3
* NOTE: It takes approximately twelve seconds from the time the fill JIB button is pressed until the fresh bulk
oil pump starts. It may take up to 20 seconds before the level in the JIB begins to rise. Typically,
it takes approximately three minutes to fill the JIB. It takes approximately two minutes to fill a full
vat.

APPENDIX A: BULK OIL INSTRUCTIONS

Bulk wiring
connection
easyTouch fryers, The momentary switch used to reset the ATO system is also
™
used to fill the jug or saddle in a fresh bulk oil system. After
clearing the TOP OFF EMPTY display, pressing and holding the
momentary switch, located above the JIB, allows the operator
to fill the jug or saddle from the bulk oil storage tank (see
Figure 4).
To fill the jug, press and hold the JIB reset button until the jug
is full, then release. *
NOTE: Do NOT overfill the jug or
saddle.
For instructions on filling the vat from
bulk, see the FilterQuick Controller
Manual Section 1.9.8.
®
SERIES ELECTRIC FRYER
Waste Oil
Connection
Figure 1
Figure 2
A–1
Fresh Oil
Connection
WARNING:
Do not add HOT
or USED oil to a
JIB or fresh oil
saddle reservoir.
Figure 4