Table of Contents
Advertisement
Do not spray aerosols in the vicinity of this appliance while it is in operation.
No structural material on the fryer should be altered or removed to accommodate placement of the fryer under
a hood. Questions? Call the Frymaster Dean Service Hotline at 1-800-551-8633.
NEVER drain boil out or cleaning solution into a shortening disposal unit (SDU), a built-in filtration unit, a
portable filter unit. These units are not intended for this purpose and will be damaged by the solution and void
the warranty.
Prior to movement, testing, maintenance and any repair on your Frymaster fryer; disconnect ALL electrical
power cords from the electrical power supply.
No warranty is provided for any Frymaster fryer used in a mobile or marine installation or concession.
Warranty protection is only offered for fryers installed in accordance with the procedures described in this
manual. Mobile, marine or concession conditions of this fryer should be avoided to ensure optimum
performance.
Do not block the area around the base or under the fryers.
This equipment is intended for indoor use only. Do not install or operate this equipment in outdoor areas.
Do not use water jets to clean this equipment.
If the electrical power supply cord is damaged, it must be replaced by a Frymaster Factory Authorized Servicer
or a similarly qualified person in order to avoid a hazard.
All wiring connections for this appliance must be made in accordance with the wiring diagram(s) furnished with
the appliance.
Refer to the wiring diagram(s) supplied with the fryer when installing or servicing this
equipment.
Do not operate this equipment unless all covers and access panels are in place and properly secured.
Building codes prohibit a fryer with its open tank of hot oil being installed beside an open flame of any type,
including those of broilers and ranges.
DANGER
DANGER
WARNING
DANGER
NOTICE
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
DANGER
iii
Advertisement
Table of Contents
Troubleshooting
