Inspection Mode - Subaru Legacy 2002 Service Manual

Engine (Diagnostics)

12. Inspection Mode

A: OPERATION
1. PREPARATION FOR THE INSPECTION
MODE
S078510A1601
Raise the vehicle using a garage jack and place on
safety stands or drive the vehicle onto free rollers.
WARNING:
¼ Before raising the vehicle, ensure parking
brakes are applied.
¼ Do not use a pantograph jack in place of a
safety stand.
¼ Secure a rope or wire to the front and rear
towing or tie-down hooks to prevent the lateral
runout of front wheels.
¼ Do not abruptly depress/release clutch pedal
or accelerator pedal during works even when
engine is operating at low speeds since this
may cause vehicle to jump off free rollers.
¼ In order to prevent the vehicle from slipping
due to vibration, do not place any wooden
blocks or similar items between the safety
stands and the vehicle.
¼ Since the rear wheels will also rotate, do not
place anything near them. Also, make sure that
nobody goes in front of the vehicle.
2. SUBARU SELECT MONITOR
After performing diagnostics and clearing the
memory, check for any remaining unresolved
trouble data.
INSPECTION MODE
S078510
S078510A16
B2M2969A
S078510A1602
1) Prepare Subaru Select Monitor kit. <Ref. to
EN-8, PREPARATION TOOL, General Descrip-
tion.>
2) Connect diagnosis cable to Subaru Select
Monitor.
3) Insert cartridge into Subaru Select Monitor.
<Ref. to EN-8, PREPARATION TOOL, General
Description.>
4) Connect test mode connector at the lower por-
tion of instrument panel (on the driver's side), to
the side of the center console box.
EN-42
S2M0285
S2M0286A
B2M3716