Stop Light Switch - Subaru Legacy 2002 Service Manual

Brake

17. Stop Light Switch

A: REMOVAL
S405542A18
1) Disconnect battery ground cable.
2) Disconnect stop light switch connector.
3) Loosen nuts, and unscrew stop light switch to
remove.
(1) Stop light switch
B: INSTALLATION
1) Screw the stop light switch onto a bracket and
secure it temporarily with a nut.
2) Adjust stop light switch position, and then
tighten the nut.
<Ref. to BR-57, ADJUSTMENT, Stop Light
Switch.>
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
STOP LIGHT SWITCH
S405542
B4M1753D
S405542A11
B4M1753E
BR-56
C: INSPECTION
1) If stop light switch does not operate properly (or
if it does not stop at the specified position), replace
with a new one.
Specified position: L
+1.5
2 / mm (0.079
0
2) Measure the clearance between threaded end
of stop light switch and stopper.
CAUTION:
Be careful not to rotate stop light switch.
Stop light switch clearance: A
0.3 mm (0.012 in)
(1) Stop light switch
(2) Stopper
(3) Brake pedal
3) If it is not in specified value, adjust it by adjust-
ing position of stop light switch.
CAUTION:
Be careful not to rotate stop light switch.
S405542A10
+0.059
/ in)
0
G4M0327
B4M0617E