Stop Light Switch - Subaru LEGACY Service Manual

17.Stop Light Switch

A: REMOVAL
1) Disconnect battery ground cable.
2) Disconnect stop light switch connector.
3) Loosen nuts, and unscrew stop light switch to re-
move.
(1) Stop light switch
B: INSTALLATION
1) Screw the stop light switch onto a bracket and
secure it temporarily with a nut.
2) Adjust stop light switch position, and then tighten
the nut.
<Ref. to BR-56, ADJUSTMENT, Stop Light
Switch.>
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
STOP LIGHT SWITCH
( 1 )
BR-00182
T
BR-00183
BR-55
C: INSPECTION
1) If stop light switch does not operate properly (or
if it does not stop at the specified position), replace
with a new one.
Specified position: L
+1.5
2 / mm (0.079
0
L
2) Measure the clearance between threaded end of
stop light switch and stopper.
CAUTION:
Be careful not to rotate stop light switch.
Stop light switch clearance: A
0.3 mm (0.012 in)
(1) Stop light switch
(2) Stopper
(3) Brake pedal
3) If it is not in specified value, adjust it by adjusting
position of stop light switch.
CAUTION:
Be careful not to rotate stop light switch.
BRAKE
+0.059
/ in)
0
BR-00109
( 1 )
A
( 2 )
( 3 )
BR-00110