Speedometer Gear - Subaru Legacy 2002 Service Manual

20. Speedometer Gear

A: REMOVAL
S503268A18
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-31, REMOVAL, Manual
Transmission Assembly.>
2) Remove back-up light switch and neutral posi-
tion switch. <Ref. to MT-40, REMOVAL, Switches
and Harness.>
3) Remove transfer case with extension case
assembly. <Ref. to MT-44, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove transmission case. <Ref. to MT-56,
REMOVAL, Transmission Case.>
5) Remove vehicle speed sensor. <Ref. to MT-42,
REMOVAL, Vehicle Speed Sensor.>
6) Remove outer snap ring and pull out speedom-
eter driven gear. Next, remove oil seal, speedom-
eter shaft and washer.
(A) Outer snap ring
(B) Speedometer driven gear
B: INSTALLATION
1) Install washer and speedometer shaft, and
press fit oil seal with ST.
NOTE:
Use new oil seal, if it has been removed.
ST 899824100 or 499827000 PRESS
2) Install vehicle speed sensor. <Ref. to MT-42,
INSTALLATION, Vehicle Speed Sensor.>
SPEEDOMETER GEAR
S503268
B3M0525C
S503268A11
MT-99
Manual Transmission and Differential
3) Install speedometer driven gear and snap ring.
NOTE:
Use new snap ring, if it has been removed.
(A) Outer snap ring
(B) Speedometer driven gear
4) Install transmission case. <Ref. to MT-58,
INSTALLATION, Transmission Case.>
5) Install transfer case with extension case
assembly.<Ref. to MT-44, INSTALLATION, Trans-
fer Case and Extension Case Assembly.>
6) Install back-up light switch and neutral position
switch. <Ref. to MT-41, INSTALLATION, Switches
and Harness.>
7) Install the manual transmission assembly to
vehicle. <Ref. to MT-33, INSTALLATION, Manual
Transmission Assembly.>
C: INSPECTION
Check the speedometer gear, oil seal and speed-
ometer shaft for damage. Replace if damaged.
B3M0525C
S503268A10