D Band Edge Beep - Icom IC-9700 Basic Manual

Setting the frequency (Continued)
Entering the Split Frequency Offset
1. Touch the MHz digits. (Example: 146)
• Opens the BAND STACKING REGISTER screen.
2. Touch [F-INP].
• Opens the F-INP screen.
3. Enter the Split Frequency Offset.
LIf you want the minus shift direction, touch [•(−)].
L Enter the offset between −9.999 MHz and +9.999
MHz (1 kHz steps).
LTo clear the entry, touch [CE].
L To clear the entry and return to the previous screen,
push .
EXIT
L After entering, the Split function is automatically
turned ON.
4. To save the entry, touch [SPLIT] or [−SPLIT].
• Closes the F-INP screen.
Entry examples
• 5 kHz: [5], [SPLIT]
• −10 kHz: [•(−)], [1], [0], [−SPLIT]
NOTE:
If the entered operating frequency is out of an
amateur band's frequency range, the transmit
frequency is automatically set to the band edge
frequency.
Selecting a Memory channel by number
1. Touch
2. Touch the MHz digits. (Example: 146)
• Opens the BAND STACKING REGISTER screen.
3. Touch [F-INP].
• Opens the F-INP screen.
4. Enter a Memory channel number. (Example: 10)
[SPLIT] or
[-SPLIT] is
displayed
L If you want to set the Program Scan Edge channel or
Call channel, enter between "100" ~ "107."
Channel type Channel number Number to enter
Programming
Call channel
5. Touch [MEMO] to select the memory channel of
entered number .
• Closes the F-INP screen.
• The selected memory channel contents are displayed.

D Band Edge Beep

You will hear a Band Edge Beep and
displayed when you tune into or out of an amateur
band's frequency range.
L You can change the Band Edge Beep settings in the
following menu.
MENU
L If the Beep Level item is set to "0%," no beep sounds.
MENU
3-6
BASIC OPERATION
to select the Memory mode.
V/M
1A
1B
2A
Scan Edge 2B
3A
3B
C1
C2
» SET > Function > Band Edge Beep
» SET > Function > Beep Level
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
100
101
17
102
103
18
104
105
106
19
107
20
21
will be