Table of Contents
Advertisement
A
& N
Z
USTRALIA
EW
The probe complies with the EMC provision of the Radio Communications Act per the following
standards, in accordance with requirements imposed by Australian Communication and Media
Authority (ACMA):
E55011/A1:2010 Radiated and Conducted Emissions, Group 1, Class A, in accordance with
EN61326-1:2013 and EN61326-2-1:2013.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia
Safety Compliance
EC D
O
ECLARATION
F
The product meets the intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-031:2002/A1:2008 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 031: Safety requirements for hand-held probe assemblies for
electrical measurement and test.
Measurement Category III (CAT III), for measurements performed in the building
l
installation.
Pollution Degree 2, operating environment where normally only dry non-conductive
l
pollution occurs. Conductivity caused by temporary condensation should be expected.
U.S. N
R
ATIONALLY
ECOGNIZED
The Probe has been certified by Underwriters Laboratories (UL) to conform to the following
safety standard and bears UL Listing Mark:
UL 61010-031-2007 - Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use - Part 031: Safety Requirements for Hand-Held Probe Assemblies for
Electrical Measurement and Test.
923278-00
D
EALAND
ECLARATION
C
- L
-V
ONFORMITY
OW
A
C
GENCY
O
C
—EMC
F
ONFORMITY
Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
OLTAGE
ERTIFICATION
Operator's Manual
27
Advertisement
Table of Contents
