Requirements - Teledyne HVD3102 Operator's Manual

HVD3102 and HVD3106 High-Voltage Differential Probes
The probe is calibrated for high precision measurements to within 1% at DC to low frequency
(~10 kHz). This provides for high accuracy of top and base voltage levels of pulse-width
modulated signals. The AutoZero capability permits further measurement precision by allowing
small offset drifts to be calibrated out of the measurement.
With the ProBus interface, the HVD310x becomes an integral part of the oscilloscope. Power is
provided to the probe through the ProBus interface, so there is no need for a separate power
supply or batteries. Attenuation (50x or 500x) is automatically selected based on oscilloscope
gain range (V/div) setting and the offset adjust is unified with that of the oscilloscope. The
sensitivity of the HVD31xx ranges from 100 mV/Div to 400 V/Div, with the maximum available
offset dependent on the V/div setting and the oscilloscope model. In general, Teledyne LeCroy
12-bit High Resolution Oscilloscopes (HRO) and HD4096 High Definition Oscilloscopes (HDO)
provide the most offset capability over the widest range of V/div settings.

Requirements

The HVD3102 and HVD3106 probes are compatible with any Teledyne LeCroy oscilloscope
equipped with the ProBus interface and XStream software version 7.4 or greater.
923278-00
4