Smeg CE6GPXU Instructions For Installation And Use Manual page 27

Instructions for the installer
15.4.2 Connection to LPG
Both the pressure regulator and the connection to the cylinder must be standards-compliant. make sure
that the feed pressure complies with the values indicated in the table at point "16.2 Burner and nozzle
characteristics table".
Screw the small hose connector F onto the large hose connector A; connect
the block this makes to the gas connector B (or use the hose connector G
which must be connected directly to the gas connector B) and place the seal
Cbetween them. Push the end of the rubber hose H onto the hose connector
A+F (or G) and at the outlet connector of the pressure reducer onto the
cylinder. Fix the end of the hose H to the hose connector A+F (or G) with the
standards-compliant clamp I
The hose connector A-F-G illustrated are not supplied with the appliance. Only use standards-compliant
hose connectors.
15.4.3 Connection with flexible steel hose (for all types of gas)
This type of connection can be made on both built-in and free-standing
appliances. Only use standards-compliant steel hoses whose length is not
greater than 2 metres.
Screw the end of the flexible hose L to the ½" OD threaded gas connector
(ISO 228-1) B placing the seal C between them.
At the end of the installation, check for any leaks with a soapy solution, never
with a flame.
59