Removing Door; Additional Maintenance - Smeg AP420X Instruction Manual

Instructions for the user

8. ADDITIONAL MAINTENANCE

The oven may require additional maintenance or replacement of parts
subject to wear such as seals, bulbs, and so on. The following
instructions describe how to carry out these minor maintenance
operations.
Before any intervention, disconnect the power supply.
8.1 Replacement of light bulb
Remove the bulb protector A by turning anticlockwise and change bulb B
(in the 8-function model with front glass panel change the halogen bulb
C) with a similar one. Re-fit the bulb protector A.
Only use oven bulbs (T 300°C).
8-functions model with glass front panel
The standard bulbs are halogen: do not touch them directly with your
fingers. Use rubber glove to protect your hand.
Use only bulbs that are available at authorised service centres.
8.2 Removing the door
Raise levers on each hinge A to lock the hinges before attempting to
remove the door. Hold the door on both sides with both hands near hinges
B. Lift up the door forming an angle of about 45° and remove. To refit, slide
the hinges A into slots in oven frame. Locate the grooves (figure C) over
51