Nmea Input Setting - JRC JMA-9133-SA Installation Manual

S2 SETTING TABLE
LOG ALARM
GYRO SIMULATOR
LOG SIMULATOR
N.A.
GYRO ALARM TIME
HEADING SENSOR SOURCE
NMEA BAUDRATE SETTING
4.1.2

NMEA Input setting

Sentences HDT and THS are effective.
The baud rate can be selected from either 4800, 9600, 19200, or 38400.
Data must be updated within 60 ms. The sensor which outputs updated data with
an interval longer than 60 ms cannot be used. (An error is indicated)
Procedures
1) To activate NMEA Input, set S2-6 at [ON].
2) Set the baud rate for S2-7,8 in accordance with the heading sensor signal
output specifications.
3) Make sure that the short plug of TB108 and 109 is located in the opposite
position of the standard position printed on the board. If it is inserted in the
default position (1-2), change it to the position between 2 and 3 as shown in
図
4-3 "TB108,TB109."
JMA-9100/7100 Installation Manual > 4.INITIAL SETTING > 4.1 GYRO INTERFACE SETTING
Table4-2： Gyro and Log Select Switches (S2 Dip Switch)
1 2
ON
OFF
ON
OFF
Don't care
5s
0.2s
4－ 5
3 4 5 6
ON
OFF
any
ON
OFF
NMEA(HDT/THS) ON
GYRO SIGNAL OFF
4800
9600
19200
38400
7 8
4
OFF OFF
ON OFF
OFF ON
ON ON