Lubrication - Grizzly G0656XW Owner's Manual

Lubrication

Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
It is essential to clean components before lubri-
cating them because dust and chips build up on
lubricated components and make them hard to
move. Simply adding more grease to them will not
yield smooth moving components.
Clean the components below with mineral spirits
or other oil/grease solvent cleaner and shop rags.
Leadscrews
Oil Type ................SB1365 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Frequency .......................................... As Needed
Lubricate with light machine oil as needed (see
Figure 57). Wipe off excess oil and sawdust with
a cloth.
Figure 57. Leadscrew lubrication location.
-36-
Table Ways
Oil Type .... Grizzly T23962 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency ....................... As Needed
Lower infeed and outfeed tables to access ways.
Place a couple of drops of oil at top of each way
as needed and move tables up and down to dis-
tribute oil (see Figure 58). Wipe off excess oil.
Figure 58. Location to lubricate table ways.
Fence
Oil Type .... Grizzly T23962 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency ....................... As Needed
Place one or two drops of light machine oil on
fence pivot points (see Figure 59) as needed.
Figure 59. Fence lubrication locations.
Model G0656W/G0656XW (Mfd. Since 08/16)