Grizzly G0656XW Owner's Manual page 24

20. Place 5 x 5 x 20 key in each handwheel
shaft keyway, then install infeed and outfeed
handwheels with the pre-installed cap screws
and flat washers (see Figure 24).
21. Secure
handwheel
handwheel (see Figure 24).
Cap Screw &
Flat Washer
Figure 24. Securing the handwheel handle.
22. Mount pedestal switch assembly to joint-
er with (2) pre-installed M8-1.25 x 20 cap
screws and flat washers (see Figure 25).
23. Thread excess switch cord through access
hole in cabinet stand (see Figure 25), and
connect it to motor cord.
Pedestal Switch
Assembly
x 2
Figure 25. Pedestal switch attached to stand.
-22-
handle onto each
Access
Hole
24. Mount foot-pedal caster to bottom of stand
using (3) M8-1.25 x 50 cap screws, (3) 8mm
lock washers, (6) 8mm flat washers, and
(3) M8-1.25 hex nuts, then re-install cabinet
stand rear access panel (see Figure 26).
Figure 26. Foot pedal and caster installed on
bottom of stand.
25. Assemble knife-setting gauge using the knife-
setting gauge rod, feet and external retaining
rings, as shown in Figure 27.
Figure 27. Knife-setting gauge assembly.
26. Install dust port as shown in Figure 28, using
(4) M5-.8 x 10 Phillips head screws and (4)
5mm flat washers.
Figure 28. Dust port installed.
Model G0656W/G0656XW (Mfd. Since 08/16)
x 3
Foot Pedal
Caster
x 4