Grizzly G0656XW Owner's Manual page 7

J
K
Figure 3. Cutterhead guard and cut depth scale.
J. Cutterhead Guard: Covers cutterhead
until pushed out of the way by workpiece
during operation. When workpiece leaves
cutterhead, guard springs back to its starting
position.
K. Depth Scale: Indicates depth of cut.
L
Figure 4. Fence tilt handle and table locks.
L. Infeed Table Lock: Tightens to secure infeed
table position; loosens to allow adjustment.
To adjust preset range of movement for
infeed table, refer to Page 28.
M. Outfeed Table Lock: Tightens to secure
outfeed table position; loosens to allow
adjustment.
Model G0656W/G0656XW (Mfd. Since 08/16)
M
N
Figure 5. Fence controls.
N. 45° Fence Stops: Stop fence at 45° inward
and 45° outward (135°).
Note: Even when fence is resting against
stops, tilt lock must be tightened before start-
ing machine.
O. 90° Fence Stop: When engaged, stops
fence at 90°.
Note: Even when fence is resting against tilt
stop, tilt lock must be tightened before start-
ing machine.
Note: Swing stop must be disengaged for
bevel cuts greater than 90°.
P. Fence Adjustment Knob: Rotates to adjust
lateral position of fence along width of tables.
Q. Fence Lock: Tightens to secure fence posi-
tion along width of tables; loosens to allow
adjustment.
R. Fence Tilt Lock: Secures fence tilt setting at
desired angle.
P
O
Q
R
-5-