Keystone ePi-2 quarter-turn electric actuator
InstallatIon and MaIntenance InstructIons
4.9 reMoVaL of the terMinaL board enCLosure
using a 5 mm allen key, loosen the four screws and remove the cover.
removal of the terminal board enclosure.
figure 8 -
4.10 CabLes ConneCtions
Before applying voltage to the ePi-2 check that the electrical parameters (supply voltage
and current) shown on the nameplate and on the attached wiring diagram are correct for the
installation.
Earth connection X
overview of the electrical connections.
figure 9 -
Warning
Pay attention not to damage the joint surfaces of
the cover.
iMportant
All the accessories which equip the EPI-2, in
particular the cable glands, must be certified
according to the Standard Directive and specific
Rules applying to the products.
Warning
Do not remove earth connection X while
connecting the actuator to plant earthing.
11