Parameterization Of The Drives - Siemens SINUMERIK 804D sl Commissioning Manual

Commissioning SINAMICS drives
8.6 Commissioning using a drive wizard
8.6.2

Parameterization of the drives

Introduction
The following components are parameterize/configured with the drive wizard:
• Motor module (power section)
• Motor
• encoder
Parameterizing/configuring
You are in the "Commissioning > Drive systems" menu
Figure 8-19
1. Press the "Drives" softkey in order to parameterize/configure the following drives:
The drive wizard identifies the relevant design of the drives and takes you through
parameterization in the dialog.
76
"Drive systems" menu after topology matching NX
– Drives with externally supplied motor
– Drives with SMI (DriveCLiQ)
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0