Drives With Smi (Drivecliq) - Siemens SINUMERIK 804D sl Commissioning Manual

Commissioning SINAMICS drives
8.6 Commissioning using a drive wizard
8.6.2.2

Drives with SMI (DriveCLiQ)

Introduction
You have a drive object with a power section (Single/double motor module), controlling a
SMI motor.
In the following operating steps you will configure/parameterize the power section, SMI
motor and sensor.
You have selected the menu "Commissioning > Drive systems > Drives". You are in the
following menu:
Figure 8-33
Operating sequences
1. Select the drive module with the vertical softkeys "Drive+/Drive-".
2. You can use the field "Recognition via LED", to check which hardware group is being
3. Press the vertical softkey "Change".
84
Menu "Drives > Configuration" (SMI)
configured.
If you click on the field, a LED on the motor module illuminates.
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0